Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
option |
$3698-6895 /Piece/Pieces
Selling Units: | Piece/Pieces |
---|
Turn off electric and pneumatic switches and close clean water and chemical control valves. The simple operation process of the screw stacking machine is as follows: Start up: turn on the electrical and gas control switches, open the water, chemical, and sludge control valves, keep the belt tight, start the engine, start the cleaning pump, check whether it meets the work requirements, start the reagent pump, start Mud pump, adjust belt speed. Adjust the flushing water pressure, adjust the dosage of reagents, mix the proportion of mud, and check the discharged mud cake. Stop: stop the mud pump, stop the chemical pump, flush the mesh belt, stop flushing the water pump, stop the main machine, loosen the mesh belt, close the electric and pneumatic switches, close the water, chemicals, and sludge control valves. Maintenance of screw stacking machine: all bearings, calcium-based grease once every half month. Pneumatic control part 30 # injection molding oil cup. The inorganic transmission is replaced every 2000 hours. Maintenance: After each work, clean the sludge on the machine body and do not flush water into the motor control box. Note the air filter water in the three connected airways. Check for loose fasteners. Check if the belt is broken. Check whether the pneumatic components are sensitive and reliable.
1. Stacked Spiral Machine structure
1. Spiral body
The laminated spiral body is composed of a fixed ring, a moving ring, a spiral shaft, a screw rod, a gasket and several connecting plates. The fixed rings are connected together by six screws, and gaskets and moving rings are installed between the fixed rings. Both the fixed ring and the moving ring are made of wear-resistant materials, giving the whole machine a longer service life. The spiral shaft passes between the fixed ring and the moving ring, and the moving ring is hollowly sleeved on the spiral shaft.
2. Spiral shaft
The spiral shaft consists of a shaft and a spiral blade, and the shaft is welded by a shaft and a hollow shaft. Assembly welding is to first weld the shaft and the hollow shaft, then perform rough turning after welding to ensure the coaxiality of both ends of the shaft, and then fully weld the spiral blades to the shaft.
3. Driving device
The drive device is the power source of the equipment. The performance of the driving device will directly affect the performance of the entire machine. For this reason, our company chooses motors with superior performance. The motor protection grade is IP54 and the insulation grade is F class. The motor complies with IEC standards and the power supply is 380V AC/3PH/50 Hz.
4. Filtrate tank
The filtrate tank is welded from plates and is used to collect the filtrate filtered out from the main body of the spirochete. The periphery of the filtrate tank is connected to the frame through screws, and there are flanges on the side of the filtrate tank to facilitate connection with external equipment. .
5. Hybrid power system
The mixing system is mainly used to fully mix the sludge and chemicals to form alum flowers, which then enter the main body of the snail pile for squeezing and dehydration.
Solid-liquid Separation works well and is very Environmentally Friendly
The file is encrypted. Please fill in the following information to continue accessing it
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.